Radiant Floor Heating in Teton Valley

Hydronic radiant heat and boiler service for Driggs, Victor, Tetonia, and the rest of Teton Valley, Idaho.

Teton Valley is one of the best places in the region for radiant floor heat. Winters at over 6,000 feet are long and cold, many new homes are built slab-on-grade or with heated garages and shops, and owners want quiet, even heat without forced air blowing dust around. JX2 Heating and Hydronics designs, installs, and repairs hydronic systems throughout the valley.

Designing radiant heat for a new build

The time to get radiant heat right is before the concrete is poured. We start with a room-by-room heat-loss calculation, then lay out tubing spacing, loop lengths, and manifold locations so every room heats evenly. We size the boiler to the real load and set up zoning and controls to match how you will use the house.

  • Heat-loss calculations for high-elevation homes
  • Slab, gypcrete, and staple-up installations
  • Manifolds, mixing, and zone controls
  • High-efficiency NTI and HTP boilers

Shops, garages, and outbuildings

A radiant slab is one of the best ways to heat a shop or garage in Teton Valley. The concrete holds heat, recovers quickly after the door has been open, and keeps snowmelt from turning the floor into a puddle. We can design a shop system to run off its own boiler or tie into the house system.

Repairs and boiler replacement

For existing homes, we troubleshoot cold zones, failed pumps and valves, and control problems, and we replace aging boilers with modern high-efficiency units. Many homes in the valley are second homes, so we also handle pre-season service to catch problems before the owners arrive.

Radiant Floor Heating & Boilers in Teton Valley: Common Questions

Do you install radiant heat in Driggs and Victor?

Yes. We serve all of Teton Valley, including Driggs, Victor, Tetonia, and Alta, for radiant floor heating design, installation, and repair.

Should my shop have its own boiler?

It depends on the distance from the house, the size of the shop, and how you use it. A separate boiler often makes sense for a detached shop, while an attached garage can usually be a zone on the house system. We will recommend the option that fits.

How early do you need to be involved in a new build?

Before the slab or subfloor goes in. Ideally we are involved during planning so the mechanical room, manifold locations, and tubing layout are designed in from the start.

Radiant Floor Heating & Boilers in Teton Valley?

Call for a free estimate or to schedule service. Emergency calls answered 24/7.